How To Replace The Gearcase In A Kenmore Direct Drive Washer

This is how to remove the gearcase from the washer

The first thing you need to do before working on the washer, is to disconnect the washer from the wall outlet. This way there will not be any electricity flowing through the washer when you are working on it.
Turn the water faucets off, put a towel on the floor to collect any water drips from the water valve and remove the two fill hoses from the washer washer repair altadena.
You will need to make sure that the washer is empty of water before removing the drain hose
Move the towel and put it under the drain hose to catch any water left on the pump and remove the drain hose
Open the door and remove the agitator
Put something on the floor to protect the washer and lay the washer down on its back
Disconnect the drain hose from the pump.
Disconnect the tub to pump holds and remove it
Disconnect the wire harness from the motor, start capacitor and from the plastic wire hanging clip
Unscrew the tree gearcase holding screws or bolts
Now the gearcase is ready to be removed. You will need to be careful when removing the gearcase because the gearcase the motor and the pump are altogether and they’re pretty heavy
Grab the gearcase and start pulling it out. Sometimes it will come out very easily and other times it will be a little harder to remove it
After removing the gearcase from the washer unit remove some parts from the old gearcase and installed them on the new gearcase
How to prepare the new gearcase before installing it

You could put the gearcase on top of a table or if you have a vice to hold it in place it will be even better
Remove the clutch assembly and install it on the new gearcase
Disengage the motor holding clips and remove the motor from the gearcase
Next you will need to remove the motor mounting plate from the bad gearcase and install it on the new gearcase
If the motor coupler is in good condition you could reuse it, but the best thing to do is to replace it with a new one
After installing the motor couple of on the new gearcase is time to install the motor
Now the gearcase is ready to be installed
How to install the gearcase

Before installing the gearcase in the machine you will need to reset brake cam
To reset the brake cam do the following. Grab the brake camp and turn it counterclockwise to release the brake and push it all away in as you turning it
Make sure that the spring on the brake assembly is on top
Also make sure that the spring on the clutch is pointing towards the motor and pump
Grab the gearcase and set it in place and screw in the three holding screws or bolts
Install the tub to pump and the drain hose to the pump
Connect the wire harness to the motor and the start capacitor and secure it to the gearcase
Stand up the washer in install the agitator
Install the drain hose and connect the fill hoses
Now the washer should be ready to be tried out
If you want to see how this repair is done click on the link on my resource box and you will be taken to my website where you can see the video for free.

Leave a Reply

Your email address will not be published. Required fields are marked *